Difference between revisions of ":Getting Started/27/en"
(Importing a new version from external source) |
(Importing a new version from external source) |
||
| Line 1: | Line 1: | ||
==Flash Again== | ==Flash Again== | ||
| − | When you need to flash a new Meteobridge firmware to your TL-MR3020 | + | When you need to flash a new Meteobridge firmware to your TL-MR3020, TL-WR703N or DIR-505, you can do that by going to "Setup Network" tab on Meteobridge web interface und pressing "Expert Mode (OpenWrt)" button. This will bring you to the openwrt SW stack below meteobridge application software stack. If your device cannot load Meteobridge application stack from the Internet for some reason, you can also directly access openwrt web interface by browsing to "http://ip-of-your-meteobridge-device/cgi-bin/luci". Login with your Meteobridge password and goto "System" tab. Select sub tab "Backup / Flash Firmware" and use offered "Flash new firmware" section. Unmark "keep settings" option and start flashing. Keep device connected to power, it will restart automatically. |
If you have a WL-330N3G, this always needs to be flashed with the TFTP environment as in setup section for that device explained. | If you have a WL-330N3G, this always needs to be flashed with the TFTP environment as in setup section for that device explained. | ||
Revision as of 23:15, 7 September 2013
Flash Again
When you need to flash a new Meteobridge firmware to your TL-MR3020, TL-WR703N or DIR-505, you can do that by going to "Setup Network" tab on Meteobridge web interface und pressing "Expert Mode (OpenWrt)" button. This will bring you to the openwrt SW stack below meteobridge application software stack. If your device cannot load Meteobridge application stack from the Internet for some reason, you can also directly access openwrt web interface by browsing to "http://ip-of-your-meteobridge-device/cgi-bin/luci". Login with your Meteobridge password and goto "System" tab. Select sub tab "Backup / Flash Firmware" and use offered "Flash new firmware" section. Unmark "keep settings" option and start flashing. Keep device connected to power, it will restart automatically. If you have a WL-330N3G, this always needs to be flashed with the TFTP environment as in setup section for that device explained.
